Washington State Department of Labor & Industries
worker fall from height

Fatal Fall Investigation Results in Citation and Fine for Aberdeen Lumber Mill

Oct. 26, 2017
An Aberdeen lumber mill has been fined $112,000 for safety violations following the death of a worker last April.

Andrew Ward, 41, an employee at Sierra Pacific Industries in Aberdeen, Wash., died when he fell from an elevated platform where he was working to the concrete surface below. An investigation by the Washington State Department of Labor & Industries (L&I) resulted in citations for Sierra Pacific Industries for seven safety violations at the lumber mill where the incident happened.

L&I’s investigation found that a section of permanent yellow guardrail was removed from the 17-and-a-half-foot-high platform and replaced with yellow caution tape so that a crane could move some equipment. When Ward went to the edge of the platform to communicate with the crane operator below, he leaned forward and fell.

“A death like this is especially tragic because it was completely preventable by using proper fall protection and following safe work practices,” said Anne Soiza, L&I’s assistant director for the Division of Occupational Safety and Health. “Falls are the leading cause of worker deaths and immediate hospitalizations. Employers need to be vigilant about preventing falls.”

The investigation found that the employer knew that caution tape cannot be used in place of guardrails at a high elevation, but still regularly allowed it to happen. Additionally, the employer was required to provide workers with a fall protection system, such as a harness, lanyard and tie-off point, while working on the elevated platform without adequate guardrails, and when removing them.

As a result, Sierra Pacific has been cited for a willful violation, the most serious, with the maximum penalty of $70,000 for not ensuring that an open-sided work platform was adequately guarded and for not ensuring employees wore fall protection equipment.

The employer was cited for an additional six serious violations, each with the maximum penalty of $7,000. Those violations covered a range of serious hazards that exposed workers to harm, including ineffective safety and health training; a safety program that wasn’t tailored to company operations; inadequate personal protective equipment training; untrained crane personnel; and not following safety precautions required for open flame work.

Because of the willful violation that led to the death of a worker, Sierra Pacific Industries has been placed on the severe violator list and will be subject to follow-up inspections to determine if the conditions still exist in the future.

The company has appealed the violations.

About the Author

Sandy Smith

Sandy Smith is the former content director of EHS Today, and is currently the EHSQ content & community lead at Intelex Technologies Inc. She has written about occupational safety and health and environmental issues since 1990.

Sponsored Recommendations

Elevating Safety: Empowering Supervisors to Become Safety Advocates

Aug. 27, 2024
Explore the skills, knowledge and techniques that supervisors need to effectively manage the safety of their crew. This guide will examine the causes and symptoms of supervisory...

Top 10 Causes of Distracted Driving—and What They All Have in Common

Aug. 27, 2024
The results reveal the top ten causes of distracted driving, and make it clear that not all distractions are created equal.

Providing the Best PPE is No Guarantee

Aug. 27, 2024
Advancements in PPE are impressive—better protection, comfort and style. But even if you’ve provided the best PPE, there is no guarantee it will be worn.

6 Qualities That Make a Safety Leader

Aug. 27, 2024
A strong safety culture depends on dedicated leaders. They are the people who spearhead the fight for a safer work environment. A good safety leader isn’t shy about bringing concerns...

Voice your opinion!

To join the conversation, and become an exclusive member of EHS Today, create an account today!